Suzuki Outboard Break In Procedure. The “break in” process for the suzuki df225 four stroke outboard is outlined below: Following these simple steps help seat the piston and make sure the motor adapts accordingly.
Tech Tip: Outboard Powerhead Break-In Procedure – Rainboat.com from rainboat.com
For the initial 2 hours: Check out my tackle shop & apparel store www.allaboutthebait.comcheck out my store www.cudatube.comsend me your. Follow those instructions to the letter.
For The Initial 2 Hours:
I'm going to show you step by step how this procedure is done. Check out my tackle shop & apparel store www.allaboutthebait.comcheck out my store www.cudatube.comsend me your. Generally speaking, you're going to baby it, i.e., no full throttle for the first few hours,.
A Good Warmup, Some Above Idle Time To Knock Down The Sharp Peaks, Then.open Up The Throttle.
For the initial 2 hours: I followed this and have over 500 hours on my 175 with no issues. When the warning lamp is off, it indicates that sufficient oil pressure is present.
Pressure Relief Bypass Valves Should Be Serviced For Correct Operation.
Follow those instructions to the letter. 16,791 views jan 5, 2017 flw pro walks you through the proper procedure to breaking in a brand new outboard. The “break in” process for the suzuki df200 four stroke outboard is outlined below:
The Process Is Fairly Simple But Very Important, To Say The Least.
I don't mean wot, i mean, get up on plane, stabilize the temps a bit and back. You'll get an owner's manual with the outboard. Flw pro walks you through the proper procedure to breaking in a brand new outboard first time owning a boat, oil leaking from bottom drain hole the “break in” process for the suzuki df2.
Allow Sufficient Idling Time For The Engine To Warm Up After Cold Engine.
Following these simple steps help seat the piston and make sure the motor adapts accordingly. The “break in” process for the suzuki df225 four stroke outboard is outlined below: Examine and/or replace the water pump or impeller.
